1) To strip the bolt, start by holding bolt handle in right hand. Pull back slightly on cocking piece and then slowly rotate it counter clockwise.
2) This is the ending position of the cocking piece.
3) Using a small flat tip, depress the retaining pin at the back of the bolt.
4) Unscrew and remove the cocking piece nut.
5) Remove the cocking piece from the bolt, it slides off.
6) Note the flat part on the firing pin. Remember this alignment to the safety lever for assembly purposes.
7) Depress the safety and rotate counter clockwise. Note the location of the pin in the notch of the bolt body.
8) Note where the pin is after releasing tension on the safety lever.
9) This is where the pin has to be in order to remove the safety and firing pin from the bolt body.
10) Press the safety in slightly and rotate it until the pin is in this side notch and the firing pin will be released. Be careful, the items are under spring tension.
11)Bolt parts.
Reassembly Instructions
12) Place firing spring on firing pin and insert into bolt body.
13) Attach safety, align pin with bolt body and press down and rotate clockwise until pin is locked into notch.
14) Note pin is aligned in notch of bolt body.
15) Push safety level down and rotate further clockwise until pin is locked into the lower portion of the bolt body (as seen in photo).
16) Rotate firing pin so that flat aligns as you noted when you dissembled the bolt.
17) Slide cocking piece onto firing pin (flat portion will have to align correctly).
18) Screw on the cocking piece nut.
19) Finally depress the retaining pin and rotate until it is tight and the pin is aligned with the notch in the cocking piece nut.
20) Grip bolt by hand, pull back on cocking piece and rotate clockwise.
